Skip to content
Frenchman's Bay Garage Door ServicesRequest a visit
Open 24/7(289) 301-8323Call now
Technician in an olive cap pointing a yellow-handled screwdriver at the wiring of a ceiling opener above a windowed door. — Toronto
Open 24/7 in Toronto

Garage Doors in TorontoKeep the weatheron the outside.

Call now · open 24/7(289) 301-8323

What's happening right now?

Door stuck open

Safely, right now

  1. Leave it where it stopped. Don't pull it down by hand or keep pressing the button.
  2. Keep the doorway clear of people, pets and vehicles.
  3. Don't pull the red release cord while the door is open. It can drop.
Call (289) 301-8323

Request a visit What the fix involves

Door won't close

Safely, right now

  1. Don't keep hitting the button. Repeated tries can do more damage than the first fault.
  2. Don't step or reach under the door to move anything. If a bin, bike or snow is in the way, mention it when you call.
  3. Leave the safety sensors near the floor as they are: never tape them or bypass them.
Call (289) 301-8323

Request a visit What the fix involves

Spring snapped

Safely, right now

  1. Leave the door and the opener alone: no lifting it by hand, no pressing the button.
  2. Nobody and nothing goes near the door: people, pets and cars stay clear.
  3. Don't pull the emergency release while the door is open. It can drop.
Call (289) 301-8323

Request a visit What the fix involves

Car stuck inside

Safely, right now

  1. Don't drive into the door or try to force it open.
  2. If there was a loud bang or the door seemed heavy, leave the release and the door alone: a spring may have snapped.
  3. Arrange another way to get where you are going for now. The car can wait inside.
Call (289) 301-8323

Request a visit What the fix involves

A cracked bottom seal lets snow, leaves and cold air into the garage and lets warmth out of the room above. For homes in Toronto we fit new bottom seals and perimeter weatherstrip sized to the door, so the garage stays drier and the furnace works less hard through the winter.

Request a visit

Same fees day or night · 19 years in business

The fix, explained · Toronto

What is the door doing?

EmergencyTorsion Spring ReplacementThe door starts to rise, gets about the height of your knee, then shudders and reverses.

The fix

The finished result is a door that behaves the way a good garage door should: it lifts by hand with light effort, stays where you leave it at mid-height, closes softly and lets the opener run with little strain. Reaching that point involves measuring the door, choosing a matched spring, winding it to the correct turns and…

Until then

  1. When a spring breaks, the safe approach for the household is to leave the door where it is, keep people and vehicles clear, and avoid running the opener, which can damage the top section, the trolley or the gear drive.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

Call (289) 301-8323Request a visit Torsion Spring Replacement

EmergencyOff-Track Garage Door ResetA delivery van backed into the shop's overhead door this afternoon.

The fix

The finish of an off-track reset matters as much as the re-seating. Once the rollers are home and the track is true, the door is disconnected from the opener and moved by hand through its whole travel while every roller is watched in its rail.

Until then

  1. Never run the opener on a door that is off its track or hanging crooked; every cycle drives the racked door harder into the rails and can pull the track from the wall or tear a hinge.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

Call (289) 301-8323Request a visit Off-Track Garage Door Reset

EmergencyGarage Door Cable ReplacementThere was a sharp crack from the garage, and when you went to look the door had dropped on one side and jammed.

The fix

Which counterbalance your door has shapes the job. Torsion doors carry a spring on a shaft above the opening, and the cables wind onto grooved drums at each end; the technician winds the spring down with steel bars, swaps the cables, sets the drums and winds it back up.

Until then

  1. Never run the opener on a door that is off its track or hanging crooked; every cycle drives the racked door harder into the rails and can pull the track from the wall or tear a hinge.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

Call (289) 301-8323Request a visit Garage Door Cable Replacement

EmergencyExtension Spring ReplacementYou pulled the red cord to open the door during a power cut and it barely moved.

The fix

What you have afterwards is a door that behaves like a much lighter object. Both corners leave the floor together, the door holds still when you stop it at waist height, and it settles onto the floor instead of slamming.

Until then

  1. When a spring breaks, the safe approach for the household is to leave the door where it is, keep people and vehicles clear, and avoid running the opener, which can damage the top section, the trolley or the gear drive.

  2. Pull the manual release only when the door is fully closed unless a technician asks otherwise; a door disconnected while partly open can move on its own if the springs are out of balance.

Call (289) 301-8323Request a visit Extension Spring Replacement

Book soonEmergency Release RepairSomeone pulled the cord last spring to get a car out during an outage, and the door has never properly rejoined the opener.

The fix

Beyond the repair, this service leaves every adult in the house able to use the release confidently. You see the handle pulled straight down with the door shut, the door lifted by its handle or a gripping point away from the panel joints, and the trolley clicked back together by pulling the cord toward the opener or running one…

Until then

  1. Pull the release with the door fully closed whenever possible, and keep the opening clear as you do.

  2. Lift a door by its handles or the gripping points on the panel face, never at the joint between sections, which closes as the door bends around the track.

Call (289) 301-8323Request a visit Emergency Release Repair

Book soonGarage Door Opener Diagnosis and RepairThe door goes up perfectly.

The fix

What you get from the visit is more than a working door. You get told, in plain words, what was wrong and why it happened: a gear that had run dry for years, a sensor knocked out of line by a snow shovel, a wall control left in lock mode by a visiting grandchild.

Until then

  1. Pull the release with the door fully closed whenever possible, and keep the opening clear as you do.

  2. Never drive a vehicle at a closed door to get out; the door collapses and the stored tension in the counterbalance is released.

Call (289) 301-8323Request a visit Garage Door Opener Diagnosis and Repair

Toronto

Garage door services · Toronto

Broken spring, snapped cable, door off the track, opener humming but not lifting, remote lost, seal cracked, panel dented, door too loud for the bedroom above: those are the calls we take from Toronto, and each has its own service page explaining how we handle it.

Bigger photo, sooner job: Emergency Book soon Plan ahead

Open 24/7 in Toronto

How a visit goes

Frenchman's Bay Garage Door Services

Job ticket · open 24/7

  1. 1 Call

    Speak with us about the work

    Describe the property, the hardware and what has changed, and the visit starts from what you have seen.

    (289) 301-8323 · open 24/7

  2. 2 Questions

    Your call, your words

    There is no wrong way to describe a garage door problem. Tell us what you saw and heard; we ask the follow-up questions.

  3. 3 On the way

    In the van

    Toronto to Malvern.

    • Torsion springs, oil-tempered or galvanized
    • Wire gauge and tape measure
    • Winding bars
    • Cable drums
    • Stationary cone bolts and nuts

  4. 4 Fixed

    Putting it right

    Finding the real cause. A door that stops halfway can be a sensor, a spring or a stripped gear. We test each possibility rather than assuming the obvious one.

    Putting it right. The technician fits the correct parts, adjusts the opener to the door, and shows you the result running through full cycles.

Same fees day, night or weekend · on-site assessment preferred

Toronto, Ontario

Toronto information

Garage Door Manual Lock Repair, Garage Door Tune-Up, Garage Door Track Repair or Replacement, Garage Door Remote and Keypad Programming, Garage Door Bottom Seal Replacement, Garage Door Hinge Replacement, Garage Door Roller Replacement, Photo-Eye Sensor Alignment or Replacement, Commercial Sectional Door Repair and Emergency Release Repair

Town
Toronto, Ontario
In business
19 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

58%

Older homes. About 58% of homes in Toronto were built in 1980 or earlier, according to the 2021 Census.

Wood door frames in an older house settle and swell over the decades, which can leave a door rubbing on one side. Rather than forcing the opener, the technician trues the tracks, adjusts the jamb seals and sets the door so it travels freely again.

23%

Single-detached houses make up about 23% of homes in Toronto (2021 Census).

Where most homes are townhouses, condos or apartments, garage doors are often shared: a single overhead door or gate serving an underground or common garage. Those doors run on commercial operators built for constant use, and their upkeep is usually arranged through the building's management.

Source: Statistics Canada, 2021 Census of Population

Nearby

Open Toronto in Google Maps
Technician in a mesh cap and safety glasses holding a wrench to a bracket at the bend of the metal door track. — Toronto
  • 19years in business
  • 24/7open, every day
  • Same feesday, night or weekend
  • On siteassessment preferred

Tell us what your door in Toronto is doing.

Our commercial customers in Toronto run shops, warehouses and service bays that depend on their doors. We set up maintenance visits at intervals that suit the door's cycle count, keep records of the springs and operators on each door, and turn up with the right parts so downtime stays short.

Malvern

  • Explained on the spot. As each part is checked, the technician tells you what it shows and what it means for the door as a whole.

  • Tidiness as standard. Old springs, cables and packaging leave with us, and the workspace is swept. A clean finish is part of every visit.

  • Options at your pace. Hear the choices, ask your questions, take the time you need. The work starts when you say so and not before.

Speak with us about the work: (289) 301-8323

Asked and answered

Advice · (289) 301-8323

How long does a tune-up take?

For a single or double residential door with an opener, allow roughly an hour to two hours on site. The inspection and the two observed cycles take a fixed amount of time; the rest depends on how many fasteners have loosened, whether the sensors need realigning and whether you approve a small part replacement, such as a worn roller, during the same visit. Spring or cable work, if found necessary, is scheduled as its own job.

The seal looks fine, so why is there still daylight under the door?

A seal can look intact and still have taken a permanent set, so the bulb no longer springs up to fill the gap. Otherwise the gap belongs to something else: a door hanging out of level, a bowed bottom section, a floor that has settled at one end, or an opener down limit set so the door stops short. The first look during the visit sorts these apart so the fix goes to the right place.

Why should the opener never run with the manual lock engaged?

Because the opener is strong enough to lift a door heavier than a person, and it has no way of knowing a bar is in the track. It pulls, the bar bends, the lock body tears at its screws, the section can crease and the opener's gear or trolley takes the shock. Opener makers ask for manual locks to be disabled or removed when a motor is installed for exactly this reason.

Can I replace just the one roller that looks bad?

One roller can be changed on its own, and sometimes that is the sensible stopgap after a wheel breaks. The better result comes from a full set, because the other wheels have done the same number of cycles and are close behind, and mixing new with old, or nylon with steel, leaves the door running unevenly and sounding different on each side. A matched set also lets the technician set every top fixture and check every hinge in one pass.

Open 24/7

Request a visit

Tell us what your door in Toronto is doing.

Call now · open 24/7(289) 301-8323
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 19 years in business